Dale it's not a bad first design. We could call it the RF experimenter's model. Could we modify it a little? If so a couple of questions on the design.
Are we assuming it is preloaded with hydrogen?
Can you add a solenoid around the bottom part (where the powder lies) of the reaction chamber? Will mean an etch into the metal.
What metal is it made out of, stainless steel? What type?
What are u using for resistive heating, just the RF?
If not then I would add a resistive heating plate at the bottom of the core, outside.
I'm not entirely sure we need completely separate reaction chambers, for example we may just need one spark plug feeding all of them, that would cut down the cost and complexity.
Can you cut out a hole on each reactor wall and weld in a piece of copper to use as a heat sink, assuming the center is for where you have a hole bored out for cooling liquid to pass through.
Thanks
Lui
|